What is included in the commissioning of the solar street light installation system?

Commissioning and maintenance of the solar street light installation system Before the solar street light is installed and hoisted, a battery test should be used to see whether the light can be lit, so as to avoid being discovered after the hoisting is completed and increase the maintenance cost. 1. Time control function settings. According to the daily lighting time designed in the design plan, set the time control node according to the instructions of the controller. The lighting time every night should not be higher than the design value, but only equal to or less than the design value. 2. Simulation of light control function. If it is during the day, after wiring, you can completely block the light-facing surface of the battery module with an opaque object (or remove the battery module wiring on the controller). According to the delay time mentioned in the controller manual (usually 5min), see After the corresponding time, whether the solar street light can be automatically lit, if it can be lit, it means that the light control opening function is normal, and if it cannot be lit, it means that the light control opening function is invalid, and the controller setting needs to be re-checked. If it is normal, remove the shield of the solar cell module (or connect the power cord of the battery module on the controller), the light source can be automatically turned off, indicating that the light control switch function is normal. The quality of the use and maintenance of solar street lights directly affects the service life of solar street lights, affects the operating cost of solar street lights, and affects efficiency. The maintenance of solar street lights is the best way to maintain the good operation of the system. For details, please log in: www.chz-lighting.com.