What are the requirements for the selection of light sources for solar garden lights?

The solar garden light source is composed of a lamp body with a heat sink, an LED module, a light-transmitting cover, a cover plate, and a sealing strip. One end of one side of the heat-dissipating lamp body is provided with a light source room. There is a tempered glass light-transmitting cover around the mouth. There are five module mounting surfaces with different angles in the light source room of the heat-dissipating lamp body, and 3-5 different modules need to be installed on the light guide mounting surface of the light source room according to different configurations. The LED module is packaged with a multi-chip and a heat sink as a whole. The guidance of light is an important part of the design of solar garden lights. In order to effectively use light, the advantage of the LED light source's easy adjustment should be taken into account, so that the light emitted by the LED light source forms a light strip and spreads on the road, instead of ineffective directions. To achieve this, LED modules of various powers are used in structure, so as to distribute and take into account different illumination distances. Make the light output by the LED light source evenly cover the distance between the two lamps on the road, and the coverage width is basically consistent with the width of the road, so that the road can be effectively illuminated with relatively small power. Therefore, it is necessary to design the installation angles of these groups of LED modules to solve the light guidance. For example, an LED light source with a power of 96W can exceed the lighting effect of a 250W sodium lamp on the road surface, and the design should be based on the factors of the product itself and the external temperature. , wind factor and daily light, etc., after comprehensive calculation, the most suitable parameters are obtained, and then production and installation are carried out. For details, please log in: www.chz-lighting.com.