Installation requirements of batteries for solar street light assembly

Tools and equipment required for installing solar street lights: multimeter, large wrench, thin iron wire, nylon cable ties, shovel, lifting rope (the material is soft belt; if it is a steel wire rope, the wire rope must be wrapped with cloth tape or when starting and adjusting the lamp, pad There are soft objects to avoid damage to the lamp body), cranes, lift trucks, etc. Battery installation requirements: 1) Remove the soil and other debris in the cement tank where the battery compartment is placed in the foundation of the solar street light to ensure that the drainage holes are not blocked by foreign objects; 2) Check whether the battery compartment is damaged, and check whether the battery voltage is normal. If it is judged as a non-conforming product, installation is prohibited. Wrap the poles of the sheathed wire with insulating tape. 3) Disassemble the battery compartment, lift it with a crane and put it into the pre-laid foundation, then put two double steel wire hoops on the connecting hose, and then pass the battery wire through the prefabricated pipe of the ground cage, and place the prefabricated pipe on the After evenly coating a layer of 7091 sealing silicone, insert the other end of the connecting hose into the root of the prefabricated pipe, and use a flat-blade screwdriver to fasten the bolts on the double-wire hoop. After the battery wire is passed out of the prefabricated tube, put on a length of threading hose, put 2 double steel wire hoops on the threading hose, and evenly coat the prefabricated tube with a layer of 7091 sealing silicone, and then soften the threading. Insert the tube into the root of the prefabricated tube, fasten the bolts on the double steel wire hoop with a flat-blade screwdriver, and finally fix the battery wire to the solar street light at the mouth of the tube. 4) Remove dirt, fine sand and other impurities in the foundation where the cover plate is placed; 5) Adjust the cover plate, place it in the foundation and place it stably. When placing the cover plate, avoid the sediment around the foundation falling into the foundation; 6) Use a mixture of asphalt and fine sand (asphalt: fine sand u003d 1:3) to cover the cover plate and the surrounding 40mm of the cover plate; 7) Fill with clay or tri-bond soil . When filling with clay or triple soil, every 10cm of filling should be rammed until the solar street light is 10cm above the ground;