Installation details of garden lights

1. Pay attention to safety and prevent electric shock. 2? Identify the positive and negative electrodes and apply thermal grease. 3. The dosage should be moderate, about 0.03 grams, and the coating should be uniform. 4. Be careful that the silicone grease contaminates the surface of the garden lamp body, surrounding objects and the human body. Fixing the lamp board Place the lamp boards coated with silicone grease on the bottom of the lamp housing one by one, so that the two screw holes of each lamp board are aligned with the corresponding fixing holes of the lamp housing. Fasten with M3X5 round head Phillips stainless steel screws. 5. The installation direction of the light panels should be consistent and neatly arranged to avoid unevenness or gaps in the installation of reflectors. 6. The screws should be tightened. Take the prepared wires for welding, the red wire is connected to the positive electrode, the black wire is connected to the negative electrode, and all the light boards are welded in parallel with a soldering iron. Take the lead of the finished lamp board? The red wire is to the positive pole, the black wire is to the negative pole, and the tinned end is welded to the middle garden light board with a soldering iron, and the other end is led along the inner edge of the lamp shell to the lower end plug. The wiring is flat. The solder joints are bright, plump and burr-free. To fix the reflector, take the reflector, put it on the lamp board, align it with the fixing hole, and let the lamp beads all expose the round hole of the reflector, and use M3X12 stainless steel round head cross bolts to tighten them one by one. Do not touch the reflector surface directly with your hands. The surface of the reflector is flat and seamless. ? Install the glass cover and cut the waterproof silicone strips at both ends, the length is 2CM longer than the long side of the glass cover. Use tweezers and a small flat-blade screwdriver to press the waterproof tape into the grooves on both sides of the garden light shell, leaving 1cm at each end. Use two people to tighten the two ends of the waterproof adhesive strip, and use another person to take the glass cover and insert it into the groove with the front side up, and cut off the excess adhesive strips at both ends. 7. When pulling the rubber strip, the force should be even and moderate, and it should not be too violent to prevent it from breaking.