Some minor problems of solar LED street lights after the installation is completed

　　 With the increasing importance of energy saving and environmental protection, solar LED street lights have been widely used, so what problems do you regret after the installation of solar LED street lights? Changhui solar street light manufacturers tell you about the problems that need to be paid attention to after the installation of solar LED street lights.　　Solar LED street lights should be installed on sunny days. If they are installed on a cloudy or rainy day, after the installation is completed and normal lighting is completed, charging cannot be carried out during the day, and electricity will be consumed at night, which will not meet the design requirements. Don’t let the street lights be illuminated at night after installation. Many manufacturers are eager to let customers see the lighting effects. After installation, they will let the street lights illuminate the night, because the new battery is not fully charged at the factory time. If the installation is completed If lighting is carried out, the lighting requirements for the number of cloudy and rainy days may not be met. There is also the problem of the angle of solar panels. Generally, manufacturers design at an inclination angle of 45 degrees to ensure a better charging capacity in winter. However, the direction angle is generally determined when the solar panel is assembled. , It is found that after the light pole is erected, the angle is deviated. If the deviation is almost the same, it is generally not adjusted. The angle deviation of solar LED street lights not only affects charging, but also affects the voltage of solar panels under the same illuminance, which will cause a relatively large error in the turn-on time of solar LED street lights. Therefore, when assembling on the ground, try to adjust the azimuth angle of the solar panels to be consistent.　　 The connection of the controller should use a waterproof controller as much as possible to ensure long-term stability while preventing customers from changing the lighting time at will. Customers should try to persuade customers to use better quality copper core wires. Due to the electrical conductivity, current and voltage will be lost during the output process, which not only increases power consumption, but can also lead to LED driving power in severe cases. Can't work normally.